Oil

Reverse CameraTurn Signals LightCar ClipsCar Detailing BrushGPS Speedometer Oil Transfer Pump Extractor Electric Fast Change Transmission Fluid Extractor

Features:

100% brand new and high quality

Widely used in general industrial equipment, medical equipment, chemical equipment, shipbuilding, drinks, carpet and floor cleaning, water purification and water treatment equipment, vehicle cleaning, agricultural spraying, zo pipeline pressure, air cleaning cooling, coal and metallurgical industries.

The advantage of the plastic tube relative to the copper tube is that it is more resistant to high temperatures and has high applicability.

 

Note:

If you want to connect this pump to AC power, you will need a power conve.

This pumping unit is designed for pumping engine oil. The gasoline and diesel also can be pumped, but the gasoline is highly corrosive, and the residual gasoline needs to be cleaned immediately after each use, which can prolong the service life. If it is not cleaned, it can only be used twice!

 

Using Method:

1. Start to run the car engine for a while, when oil temperature turns to be about 50 degrees, start pumping oil.

2. Connect the pump to the power, run it for a while, and observe whether the inlet and outlet is normal.

3. Open the filler cap,get dipstick out, force the tube into the bottom of the joint, until the tube does not move.

4. Put the inlet pipe from the oil dipstick into in end (the tube into the bottom of the tank, the bottom concave place, in order to pump the oil completely.As no oil or pumping up very slowly or intermittently, it is generally caused by loose pipes and fittings. You have to install the pipes and fittings again.)

5. After oil pumping, remove the tube, and then run the pump for a while, pump the remaining oil inside the pumping clean, or pump water for a while until the pump head gets clean.

6. If you have not used it for a long time, it may have no suction, then just pour the water in the pump, and run the pump for a few minutes until the air is all out.

 

Specification:

Rated Voltage: DC 12V

Rated Power: 60W

Maximum Flow: 5L/min

Maximum Pressure: 0.8MPA

Pump Diameter: Approx. 4.5cm

Length: Approx. 14.5cm

Cable Length: Approx. 36cm

Clips Length: Approx. 8cm

PVC Outlet pipe Length:145cm

Nylon pipe Length:100cm

Plastic pipe Length:100cm

Color:as picture show

 

What is included:

1x Oil Pump

1x Outlet pipe

1x 6X4mm Nylon pipe

1x 8X5mm Plastic pipe

Payment

• We accept Paypal only.

Shipping

• Shipped within 2 business days after payment cleared.
• No shipment to PO Boxes, FPO and APO addresses.
• We only ship to Paypal address. Pls make sure your Paypal address is your shipping address.

Feedback

• Positive feedback will be left after shipment.
• Your five star positive feedback is highly appreciated.
• Pls don't leave netrual or negative feedback before contacting us.

Contact US

We are the manufacturer of shipping labels.

Any questions,pls don't hesitate to contact us through Ebay message.

Shop Category Store Home  4X6 Thermal Label for DYMO 4XL  4X6 Thermal Labels on Roll ◈  250 Labels Per Roll ◈  450 Labels Per Roll ◈  500 Labels Per Roll  A4 8.5"x5.5" Shipping Label ◈  Round Corner ◈  Straight Corner  Fragile Stickers ◈  3" X 5" Fragile Stickers ◈  2" X 3" Fragile Stickers  Poly Mailier Bags ◈  9" x 12" ◈  10" x 13" ◈  12" x 15.5" ◈  14.5" x 19"  Thermal Receipt Paper  Car Accessories  Wholesales  Electronic Product Accessories  Lights  4X6 Fanfold thermal labels  Vacuum Sealer Bags  Printable Vinyl Sticker Paper  Price coding paper  Direct Thermal Labels  Plotter Paper  Thermal Laminating Pouches  Clear Envelope Pouches  Clear Poly Bags  Full Sheet Shipping Labels  OtherNew List ItemHot ItemPicture